MyIPCam for IP cameras értékelései
MyIPCam for IP cameras szerző: Denfllow
12 értékelés
- Csillagos értékelés: 1 / 5készítette: BrunoAragao, 2 éve
- Csillagos értékelés: 1 / 5készítette: Firefox felhasználó 12892113, 4 éve
- Csillagos értékelés: 1 / 5készítette: Firefox felhasználó 14190273, 4 éve
- Csillagos értékelés: 1 / 5készítette: Firefox felhasználó 16834856, 4 éveAdded this extension to my firefox and went to "manage extension" but NOWHERE did it allow ANY configuration to my IP cams. No 'Autoscan' either. As you stated: "To work you must select the camera model (or you can use 'Autoscan'),... This is a free function of the Extension." So. where do I go to configure?
- For some reason Amcrest is in the dropdown for MPEG (but doesn't work) but it's not in the IP dropdown selection list. So this doesn't work at all for my Amcrest setup.
Edit: Responded to developer, explaining that I can't use Amcrest's web interface since it keeps asking me to install their web client, which I have done several times. This was the reason I installed this extension. Awaiting additional help from developer...Fejlesztői válasz
közzétéve: 5 éveTry to open web Amcrest camera web interface. Then Open 'Video' settings and select "Encode Mode"=MJPEG for "Sub Stream". Here is full instructions:
https://twitter.com/MyIPCamApp/status/1041722224930181120 Fejlesztői válasz
közzétéve: 7 éveMain functions such as camera viewing and PTZ-control in the pop-up window are free- Csillagos értékelés: 1 / 5készítette: Firefox felhasználó 14051203, 7 éveKept popping up payment request when trying to review, would have been happy to pay a little for this if it wasn't so obnoxious! Also could not find any PTZ controls.
Fejlesztői válasz
közzétéve: 7 éveHow to find PTZ controls: open pop-up window from toolbar, click on video from camera. PTZ buttons will appears below video image. - Csillagos értékelés: 1 / 5készítette: Firefox felhasználó 13393917, 8 éveDoes not work in Firefox 64 bit